Difference between revisions of "Blog 21"
Jump to navigation
Jump to search
(Created page with "This is used for both projects: Hardware used on Raspberry Pi: *[http://www.bitwizard.nl/shop/raspberry-pi-ui-16x2 RPi_UI board] | (User Interface) *[http://www.bitwizar...") |
|||
Line 12: | Line 12: | ||
*[[Bw tool]] |
*[[Bw tool]] |
||
== |
== Connecting the analog meters == |
||
Line 34: | Line 34: | ||
IO1 + IO3 -> 02 + 08 = 0A |
IO1 + IO3 -> 02 + 08 = 0A |
||
== |
=== Making the sticker === |
||
== DIO Analog meter clock == |
|||
Revision as of 16:23, 14 December 2015
This is used for both projects:
Hardware used on Raspberry Pi:
- RPi_UI board | (User Interface)
- DIO | (DIO)
- Jumper cables M-F
- 4 PIN I2C cable F-F
- Two analog meters
Programmed with:
- Bash
- Bw tool
Connecting the analog meters
Change analog meter value through the command line
Recommended to use the DIO protocol.
I have in my example the analog meter connected with pin 3(IO0).
bw_tool -I -D /dev/i2c-1 -a 84 -W 30:01 bw_tool -I -D /dev/i2c-1 -a 84 -W 5f:01 bw_tool -I -D /dev/i2c-1 -a 84 -W 50:80
If you are going to use a pin like pin 10(IO6). With the value 40. The reason it is 40 is, because the bits are in hexadecimals. So, 64 decimal bits gets calculated to 40 hexadecimals.
The reason why this is getting used, is because it is bit masked. With that you can add multiple pins in the command. So, if you you want pin 4(IO1) and pin 6(IO3) on:
IO1 + IO3 -> 02 + 08 = 0A
Making the sticker
DIO Analog meter clock
DIO Cooking timer
Pin | Function | Value |
---|---|---|
3 | IO0 | 01 |
4 | IO1 | 02 |
5 | IO2 | 04 |
6 | IO3 | 08 |
8 | IO4 | 10 |
9 | IO5 | 20 |
10 | IO6 | 40 |