Difference between revisions of "FTDI serial 2"
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
This is the documentation page for the FTDI-serial 2 board. That you can buy in the [http://www.bitwizard.nl/shop/usb-boards/usb-uart-ftdi BitWizard shop]. |
This is the documentation page for the FTDI-serial 2 board. That you can buy in the [http://www.bitwizard.nl/shop/usb-boards/usb-uart-ftdi BitWizard shop]. |
||
== |
== Overview == |
||
The FTDI-serial 2 board has an USB connector and a 4-pin serial/UART connector. The brains of the PCB is an FT232RL chip. |
The FTDI-serial 2 board has an USB connector and a 4-pin serial/UART connector. The brains of the PCB is an FT232RL chip. |
||
| Line 7: | Line 7: | ||
== External resources == |
== External resources == |
||
== |
== Pinout == |
||
The 4 pin connector is connected as follows |
The 4 pin connector is connected as follows |
||
| Line 28: | Line 28: | ||
2-3: 5V (place jumper near UART header)<br> |
2-3: 5V (place jumper near UART header)<br> |
||
== |
== Future hardware enhancements == |
||
Latest revision as of 17:53, 6 November 2015
This is the documentation page for the FTDI-serial 2 board. That you can buy in the BitWizard shop.
Overview
The FTDI-serial 2 board has an USB connector and a 4-pin serial/UART connector. The brains of the PCB is an FT232RL chip.
External resources
Pinout
The 4 pin connector is connected as follows
| 1 | Ground (G) |
| 2 | Rx (R) |
| 3 | Tx (T) |
| 4 | VCC (T) |
- led1 is connected to CBUS0 (Tx activity)
- led2 is connected to BCUS1 (Rx activity)
- led3 is connected to VCC
Jumper settings
IO voltage
1-2: 3V3 (place jumper near FTDI)
2-3: 5V (place jumper near UART header)
Future hardware enhancements
Changelog
2.0
- Size reduced considerably
- Added an VCC pin to the Rx/Tx connector
1.0
- Initial public release