Difference between revisions of "I2C DAC"
From BitWizard WIKI
(→using the board) |
(→physical dimensions) |
||
Line 8: | Line 8: | ||
You can order both versions. The addresses of your board can be found on the bottom side. | You can order both versions. The addresses of your board can be found on the bottom side. | ||
− | = | + | = Physical dimensions = |
* Board outline: 25x25mm | * Board outline: 25x25mm | ||
* Mounting hole diameter: 3mm | * Mounting hole diameter: 3mm | ||
* Mounting hole pitch: 19x19mm (3mm from board edge) | * Mounting hole pitch: 19x19mm (3mm from board edge) | ||
+ | |||
= Using the board = | = Using the board = | ||
Set a voltage: | Set a voltage: |
Latest revision as of 13:08, 11 November 2015
General info
Based on the MCP4726 chip from Microchip.
http://ww1.microchip.com/downloads/en/DeviceDoc/22272C.pdf
I2C address:
1100 000 and 1100 001 OR
1100 010 and 1100 011
You can order both versions. The addresses of your board can be found on the bottom side.
Physical dimensions
- Board outline: 25x25mm
- Mounting hole diameter: 3mm
- Mounting hole pitch: 19x19mm (3mm from board edge)
Using the board
Set a voltage:
sudo i2cset -y 1 0x60 0x40 0xff 0xf0 i ^^ ^ < Voltage bits
explanation of the arguments:
-y don't ask confirmation 1 number of the I2C bus (0 on older raspberry pi's) 0x60 address of the DAC, use 0x61 (or 0x62 and 0x63) for the other DAC. 0x40 configuration: normal. 0xff high 8 bits of the value 0xf0 lower four bits of the value (in the high nibble)