Difference between revisions of "FTDI serial 2"
Jump to navigation
Jump to search
(Created page with "This is the documentation page for the FTDI-serial 2 board. == overview == The FTDI-serial 2 board has an USB connector and a 4-pin serial/UART connector. The brains of the...") |
m (→pinout) |
||
| Line 15: | Line 15: | ||
<tr><td>2</td><td>Rx (R)</td></tr> |
<tr><td>2</td><td>Rx (R)</td></tr> |
||
<tr><td>3</td><td>Tx (T)</td></tr> |
<tr><td>3</td><td>Tx (T)</td></tr> |
||
<tr><td> |
<tr><td>4</td><td>VCC (T)</td></tr> |
||
</table> |
</table> |
||
Revision as of 17:12, 18 April 2012
This is the documentation page for the FTDI-serial 2 board.
overview
The FTDI-serial 2 board has an USB connector and a 4-pin serial/UART connector. The brains of the PCB is an FT232RL chip.
External resources
pinout
The 4 pin connector is connected as follows
| 1 | Ground (G) |
| 2 | Rx (R) |
| 3 | Tx (T) |
| 4 | VCC (T) |
- led1 is connected to CBUS0 (Tx activity)
- led2 is connected to BCUS1 (Rx activity)
- led3 is connected to VCC
Jumper settings
IO voltage
1-2: 3V3 (place jumper near FTDI)
2-3: 5V (place jumper near UART header)
future hardware enhancements
Changelog
2.0
- Size reduced considerably
- Added an VCC pin to the Rx/Tx connector
1.0
- Initial public release