Difference between revisions of "Solder jumpers"
Jump to navigation
Jump to search
(Created page with '== Solder jumpers == none|thumb|300px|alt=Trace still intact|Trace still intact Carefully(!!!) cut the naroow trace between the middle and righ…') |
|||
| (One intermediate revision by one other user not shown) | |||
| Line 2: | Line 2: | ||
[[File:solder_jumper_normal.JPG|none|thumb|300px|alt=Trace still intact|Trace still intact]] |
[[File:solder_jumper_normal.JPG|none|thumb|300px|alt=Trace still intact|Trace still intact]] |
||
Carefully(!!!) cut the |
Carefully(!!!) cut the narrow trace between the middle and right pad with a sharp knife: |
||
[[File:solder_jumper_cut.JPG|none|thumb|300px|alt=Trace is cut|Trace is cut]] |
[[File:solder_jumper_cut.JPG|none|thumb|300px|alt=Trace is cut|Trace is cut]] |
||
Note that you can now see the bare color of the PCB, a yellowish colour. The green you know from PCBs is the solder mask that is often used. |
|||
Place a solder jumper over the other two pads: |
Place a solder jumper over the other two pads: |
||
[[File:solder_jumper_soldered.JPG|none|thumb|300px|alt=New connection is created|New connection is created]] |
[[File:solder_jumper_soldered.JPG|none|thumb|300px|alt=New connection is created|New connection is created]] |
||
Latest revision as of 17:06, 4 November 2016
Solder jumpers
Carefully(!!!) cut the narrow trace between the middle and right pad with a sharp knife:
Note that you can now see the bare color of the PCB, a yellowish colour. The green you know from PCBs is the solder mask that is often used.
Place a solder jumper over the other two pads:
