Difference between revisions of "Dio breakout"
| (5 intermediate revisions by 2 users not shown) | |||
| Line 10: | Line 10: | ||
None: the board comes fully assembled. |
None: the board comes fully assembled. |
||
== Additional software == |
|||
| Line 90: | Line 88: | ||
|} |
|} |
||
d.n.c. means do not connect. |
|||
| ⚫ | |||
| ⚫ | |||
| ⚫ | |||
== Configurations == |
|||
You can chose to have your board equipped with a 10-pin female connector that allows your board to directly fit on top of the I2C-DIO board. This would conflict with the SPI connectors so don't chose this option for an SPI_DIO. |
|||
| ⚫ | |||
You can chose to have your board equipped with a male 10-pin connector that allows you to connect your board with the SPI_DIO or I2C DIO using a short 10pin IDC cable. |
|||
== Future hardware enhancements == |
== Future hardware enhancements == |
||
may 2013: This is vaporware: hardware will be available june 2013. |
|||
== Future software enhancements == |
== Future software enhancements == |
||
Latest revision as of 13:06, 10 December 2015
This is the documentation page for the DIO_breakout .
Overview
This board enables use screw terminals to connect wires to your SPI_DIO or I2C_DIO board.
Assembly instructions
None: the board comes fully assembled.
Related projects
Pinout
The connector at the bottom of the board is laid out as follows:
| pin | function |
|---|---|
| 1 | GND |
| 2 | IO0 |
| 3 | IO1 |
| 4 | IO2 |
| 5 | IO3 |
| 6 | IO4 |
| 7 | IO5 |
| 8 | IO6 |
the power-connector at the top of the board is laid out as follows:
| pin | function |
|---|---|
| 1 | GND |
| 2 | VCC |
| 3 | GND |
| 4 | VCC |
| 5 | GND |
| 6 | VCC |
| 7 | GND |
| 8 | VCC |
The dataconnector in the middle of the board is compatible with the DIO board:
| pin | function |
|---|---|
| 1 | GND |
| 2 | VCC |
| 3 | IO0 |
| 4 | IO1 |
| 5 | IO2 |
| 6 | IO3 |
| 7 | d.n.c. |
| 8 | IO4 |
| 9 | IO5 |
| 10 | IO6 |
d.n.c. means do not connect.
Jumper settings
There are no jumpers.
Configurations
You can chose to have your board equipped with a 10-pin female connector that allows your board to directly fit on top of the I2C-DIO board. This would conflict with the SPI connectors so don't chose this option for an SPI_DIO.
You can chose to have your board equipped with a male 10-pin connector that allows you to connect your board with the SPI_DIO or I2C DIO using a short 10pin IDC cable.
Future hardware enhancements
may 2013: This is vaporware: hardware will be available june 2013.
Future software enhancements
Changelog
1.0
- Initial public release