Difference between revisions of "FTDI serial"
Jump to navigation
Jump to search
(Created page with '= FTDI-serial board = This is the documentation page for the FTDI-serial board. == overview == The FTDI-serial board has an USB connector and a 3-pin serial/UART connector. T…') |
|||
| Line 28: | Line 28: | ||
== future hardware enhancements == |
== future hardware enhancements == |
||
== Changelog == |
|||
1.0 |
|||
* Initial public release |
|||
Revision as of 14:30, 16 November 2011
FTDI-serial board
This is the documentation page for the FTDI-serial board.
overview
The FTDI-serial board has an USB connector and a 3-pin serial/UART connector. The brains of the PCB is an FT232RL chip.
pinout
The 3 pin connector is connected as follows
| 1 | Ground (G) |
| 2 | Rx (R) |
| 3 | Tx (T) |
- led1 is connected to CBUS0 (Tx activity)
- led2 is connected to BCUS1 (Rx activity)
- led3 is connected to VCC
Jumper settings
IO voltage
1-2: 3V3 (jumper near C2)
2-3: 5V (jumper near the edge of the board
future hardware enhancements
Changelog
1.0
- Initial public release