7FETs
This is the documentation page for the SPI_6FETs board.
Overview
The board has 7 fets that allow you to pull a pin of a load low. You would normally tie the other end of your load directly to the powersupply.
About 1A per output should be possible. Maximum voltage is 20V.
You will have to provide your own protection circuits if you are going to drive inductive loads (like a motor).
Assembly instructions
Possible Configurations
External resources
Datasheets
Additional software
Related projects
Pinout
LEDs
Jumper settings
Programming
The software
Default operation
Future hardware enhancements
Future software enhancements
Changelog
1.0
- Initial public release