Cyclone dev board
From BitWizard WIKI
Revision as of 16:19, 23 September 2011 by Tom (talk | contribs) (Created page with '= Cyclone dev board = This is the documentation page for the Cyclone dev board. == overview == The Cyclone dev board has an USB connector and 4 20-pin IO connector. The brain…')
Contents
Cyclone dev board
This is the documentation page for the Cyclone dev board.
overview
The Cyclone dev board has an USB connector and 4 20-pin IO connector. The brains of the PCB is an EP1C6T144C8 (or compatible) chip.
pinout
The 20 pin connectors are connected as follows
1 | GND |
2 | GND |
3 | |
4 | |
5 | |
6 | |
7 | |
8 | |
9 | |
10 | |
11 | |
12 | |
13 | |
14 | |
15 | |
16 | |
17 | |
18 | |
19 | VCC |
20 | VCC |
1 | GND |
2 | GND |
3 | |
4 | |
5 | |
6 | |
7 | |
8 | |
9 | |
10 | |
11 | |
12 | |
13 | |
14 | |
15 | |
16 | |
17 | |
18 | |
19 | VCC |
20 | VCC |
1 | GND |
2 | GND |
3 | |
4 | |
5 | |
6 | |
7 | |
8 | |
9 | |
10 | |
11 | |
12 | |
13 | |
14 | |
15 | |
16 | |
17 | |
18 | |
19 | VCC |
20 | VCC |
1 | GND |
2 | GND |
3 | |
4 | |
5 | |
6 | |
7 | |
8 | |
9 | |
10 | |
11 | |
12 | |
13 | |
14 | |
15 | |
16 | |
17 | |
18 | |
19 | VCC |
20 | VCC |
- led1 is connected to VCC
- led2 is connected to pin 144
- led3 is connected to conf_done
- led4 is connected to pin 143
- led5 is connected to pin 142
- led6 is connected to pin 141
programming
This section describes how you get your program into the FPGA.
Linux
windows
writing programs
The chip is an EP1C6T144C8. http://www.altera.com/literature/lit-cyc.jsp