This is the documentation page for the FTDI-serial board.
The FTDI-serial board has an USB connector and a 3-pin serial/UART connector. The brains of the PCB is an FT232RL chip.
The 3 pin connector is connected as follows
- led1 is connected to CBUS0 (Tx activity)
- led2 is connected to BCUS1 (Rx activity)
- led3 is connected to VCC
1-2: 3V3 (jumper near C2)
2-3: 5V (jumper near the edge of the board
future hardware enhancements
- Initial public release