Difference between revisions of "LCD"
(Created page with "The SPI_LCD board This is the documentation page for the SPI_LCD and I2C_LCD boards. == Overview == == Assembly ins...")
Revision as of 15:36, 21 May 2012
This is the documentation page for the SPI_LCD and I2C_LCD boards.
The board comes fully assembled.
The second SPI port can be used as an ICSP connector.
The only LED is a power indicator.
There are two solder jumpers. The one between the two 6-pin SPI connectors controls the function of the SPI connector furthest from the CPU.
In the default configuration the second SPI connector is a daisy-chain connector for the SPI bus.
In the other configuration, the second SPI connector is the ICSP connector.
There is a 10 mil (very small) PCB trace in the solder jumper in the default configuration. You'll have to cut this trace to move the solderjumper to the other position. If you later decide you want the other configuration again, some solder-wick can be used to remove the solder from one position and then it can be added to the other position.
For the intro to the SPI and I2C protocols read: SPI versus I2C protocols
You should also read the General_SPI_protocol notes.
For arduino, a sample PDE is available, called ardemo_lcd.pde, also at BitWizard software download directory .
This is a demo to send things using SPI to the lcd board. The SPI routines there are applicable for LCD boards as well.
Future hardware enhancements
Future software enhancements
- Lock the address. (require a sequence of commands to change the address).
- Initial public release