User contributions
Jump to navigation
Jump to search
- 18:15, 22 March 2012 diff hist +66 FTDI ATmega →Related projects
- 18:14, 22 March 2012 diff hist +3 Temperature control →writing the software
- 14:00, 21 March 2012 diff hist -110 FTDI ATmega →Jumper settings
- 15:42, 19 March 2012 diff hist +656 Relay
- 14:49, 19 March 2012 diff hist +24 3FETs →Pinout
- 15:58, 12 March 2012 diff hist +37 Default addresses
- 15:55, 12 March 2012 diff hist +20 Default addresses
- 15:55, 12 March 2012 diff hist +70 N Default addresses Created page with "SPI_LCD 0x82 SPI_DIO 0x84 SPI_SERVO 0x86 SPI_7FETs 0x88 SPI_3FETs 0x8A"
- 15:49, 12 March 2012 diff hist +25 Main Page →Expansion boards
- 15:48, 12 March 2012 diff hist +2,474 N 3FETs Created page with "This is the documentation page for the SPI_3FETs board. == Overview == The board has 3 fets that allow you to pull a pin of a load low. You would normally tie the other end..."
- 15:44, 12 March 2012 diff hist +16 Main Page →Expansion boards
- 14:26, 12 March 2012 diff hist +1 RGB clock →Mode 2
- 14:25, 12 March 2012 diff hist -120 RGB clock →Jumper settings
- 13:57, 12 March 2012 diff hist -6 RGB clock →Adjusting the white-balance
- 13:55, 12 March 2012 diff hist +228 RGB clock →The software
- 13:48, 12 March 2012 diff hist +12 RGB clock →Using the pushbuttons
- 13:45, 12 March 2012 diff hist 0 m RGB clock →Reading back the time
- 11:25, 10 March 2012 diff hist +4 Modifying the arduino IDE for 20MHz current
- 11:18, 8 March 2012 diff hist -40 7FETs
- 20:41, 7 March 2012 diff hist +23 USB-multio →Additional software